Vivid Leak Sentinel V4 for Acquapazza A7 / A72 Housings
Vivid Leak Sentinel V4 for Acquapazza A7 / A72 Housings Vivid Leak Sentinel V4 for Acquapazza A7 / A72 Housings Vivid Leak Sentinel V4 for Acquapazza A7 / A72 Housings Vivid Leak Sentinel V4 for Acquapazza A7 / A72 Housings Vivid Leak Sentinel V4 for Acquapazza A7 / A72 Housings
Vivid Leak Sentinel V4 for Acquapazza A7 / A72 Housings
Mfr# LS4-AQP
Our Price: $209.95
Availability: In Stock
Qty:  
   - OR -   

For only a fraction of the price of other similar systems, you too can now have Leak Sentinel, pre dive vacuum leak detector that will eliminate guesswork about the housing tightness and let you concentrate on the photography, instead of worrying if today is maybe your turn to experience the underwater photographer's worst nightmare.
This new, improved version of Leak Sentinel features new, calibrated pressure sensor and processor. The complete electronic circuit and the battery are located in the robust anodized aluminum valve body for even more convenient operation and ease of installaton.
The green/red LEDs are visible through the transparent acrylic window, so no complicated installation around the viewfinder in non-transparent housings is required. LEDs are always visible, not only when you look through the viewfinder.
The included hand pump is lightweight and requires no batteries, so no nasty surprises when you are far from coast. It achieves required underpressure in average housing almost effortlessly.
The installation is simple and straightforward, and is in most cases done by either replacing the bulkhead, or just screwing the adapter into the accessory port. You can check the tightness immediately after installation, making the process risk-free.
Custom adapters for various housings/bulkheads are available. For more information check the link below.
The circuit is self calibrating, and as such suitable for altitude diving.

The principle of operation

The housing is closed 15-30 minutes before dive, with the camera installed and the circuit switched on. Red LED starts blinking, indicating ambient pressure. The hand pump is fitted to the threaded valve body and the air is pumped out of the housing, After approx. 20-25 strokes, the red LED stops blinking, and after a couple more strokes, the green LED starts blinking, indicating the sufficient underpressure. The additional stroke or two ensures that the circuit is not on the edge of treshold. The pump is then removed and the protective cap replaced to ensure air and water tightness. The LED is then observed. Green LED blinking indicates that there is no air leakage (safe to dive). After the dive, the protective cap is removed and the pressure is equalised with the simple movement of the rubber valve.

Function / Efficiency
Run Time 100 hours
Depth rating 100m / 330 ft.
Basic
Batteries CR1632
Dimensions 31 x 25mm (DIA x L), Valve body only.
Weight 45g
Materials Aluminum, Plastic.
  1. Anodized aluminum valve body with valve and electronics
  2. Aluminum adapter for Acquapazza A7 / A72 housings
  3. Hex wrench
  4. Hand pump with 300mm PVC tubing

 

SSL Certificate EV SSL
Copyright © 2013 DiverVision U/W Photo Equipment All Rights Reserved